Setting Up Multiple Trill Addresses in Arduino IDE

Hizumi

Hello!!
I have two Trill bars connected to Arduino and was wondering how to go about setting up two separate addresses in the Arduino IDE?
I’m guessing I have to put 0x20 and 0x21 (or 32 and 33) somewhere in the setup()? I have been using the bar-print example. And I did solder and change the address for the second bar.

Thank you for your time!

giuliomoro

you need to pass a [third argument](
https://github.com/BelaPlatform/Trill-Arduino/blob/master/Trill.h#L113) to Trill::setup(), that is the address.

For instance,

int ret = trillSensor.setup(Trill::TRILL_BAR);

will become

  int ret = trillSensor.setup(Trill::TRILL_BAR, 0x20);

  int ret = trillSensor.setup(Trill::TRILL_BAR, 0x21);

Hizumi

giuliomoro
It worked! Thank you so much!