Hi,
I have created a perfetly working copy of my live sampling software RoSa, all built in c(++), compiling without errors and running fine. The system responds to OSC messages and/or hardware i/o with buttons and pots.
But.....I defined RoSa to autoboot when the bela is powered on, but it refuses to do this.
When I start up the Bela IDE I get the following feedback:
Started Run Bela at boot.
Jun 20 15:40:50 bela stdbuf[22732]: make: Entering directory '/root/Bela'Jun
20 15:40:50 bela systemd[1]: bela_startup.service: Main process exited, code=exited, status=2/INVALIDARGUMENTJun
20 15:40:50 bela systemd[1]: bela_startup.service: Unit entered failed state.
Jun 20 15:40:50 bela systemd[1]: bela_startup.service: Failed with result 'exit-code'.
Jun 20 15:40:50 bela systemd[1]: bela_startup.service: Service hold-off time over, scheduling restart.
Jun 20 15:40:50 bela systemd[1]: Stopped Run Bela at boot.
Jun 20 15:40:50 bela systemd[1]:
Started Run Bela at boot.
Jun 20 15:40:50 bela stdbuf[22732]: make: Entering directory '/root/Bela'
Jun 20 15:40:50 bela systemd[1]: bela_startup.service: Unit entered failed state.
Jun 20 15:40:50 bela systemd[1]: bela_startup.service: Failed with result 'exit-code'.
Jun 20 15:40:50 bela systemd[1]: bela_startup.service: Service hold-off time over, scheduling restart.
Jun 20 15:40:50 bela systemd[1]: Stopped Run Bela at boot.Jun
20 15:40:50 bela systemd[1]: etc. etc.
why is that, since I do not get these errors when uploading the code again from the IDE?
thanks,
Frank