• Gliss
  • Getting started with building Gliss

Hi,
I am planning on building some Gliss's and had a couple of beginner questions which I couldn't seem to find answers for. so hope this is the right place! 🙂

I have downloaded all the hardware files, created gerbers to make the boards, so that is ok.
I couldn't find any BOMs. Is the best way to save them out of kicad?

And with the software, are there any premade binaries to flash? or should I compile them? If I need to compile them, any hints on how to get started with that?

(Also, I know the main arm chip needs to be programmed. What about the cap sense chip? does that need programming too?)

Thanks! 🙂

8 days later
6 days later

Hi @gwpt, thanks for reaching out. We provide the sources for hard and software of the Gliss module, but we can't offer support exceeding that. The team has long to-do lists for the development and documentation, please understand we need to focus on that.