Tape delay on Pepper just passes in through to out

DragonSF

I just finished building my Pepper and tested various examples. All work fine, but tape delay gives me some troubles: I can hear the input audio, the leds light up accordingly, but I can't hear no effect whatever. It can't be the pots, because the work fine with other projects. I have ATM no CV ins wired.
What am I missing? Any way to debug? FYI: the power comes from the rack.

giuliomoro

there are two controls on this patch that could cause "no noticeable effect heard":

CV in 0: tape speed [adc~ 3]
CV in 2: high-frequency rolloff [adc~ 5]
CV in 4: FX send [adc~ 7]
CV in 5: wet/dry [adc~ 8]

if either of these malfunctions (e.g.: is stuck to 0), then you would hear no (or very little) effect.

Try the following patch then open the Bela scope and verify that all pots swipe the full range:

[adc~ 3 5 7 8]
|   |    \   \
[dac~ 27 28 29 30] SEND TO SCOPE

DragonSF

Thanks for the advice. I forgot to install the 2nd analog jumpers on the last 4 analog-ins. Now it works.

DragonSF

How do these controls relate to physical data?:

speed : values cv0*5000+10  (ms?)
time: cv1*2000+15 (ms?)
FB: cv3*1.5 (dim-less number?)
Rolloff: cv2*120+30 (Hz?)
wet/dry: c5-[$1 10]-[c_xfade] (no idea)

I noticed, when the CV0 control is turned left, the speed is the highest (delay lowest) and turned full clock-wise, speed is lowest. Do I misunderstand the PD code?