Hi!
Apologies for reviving a dead thread, I was looking for resources and found this. I suddenly started getting this error notice after a few successful tests with my Trill Craft. It worked well at first and I built a small touch panel interface which was a lot of fun.
I experienced a few hang-ups of the Craft when trying to identify the sensor inputs, where slightly moving a cable would produce an error in the Craft and it would become unresponsive.
Eventually I started getting a similar error as displayed above at load (referring to the Craft instead of the Bar, of course). I don't think I did anything stupid like sending voltage to the wrong places, but is there a chance the Craft is fried as a result of something (like what caused the hang-ups)? Is there a different way to test if it still works?
Thanks!