Hi everybody,
I recently ordered a Bela mini, and when plugging the PocketBeagle, I get only a weak blink of the pwr LED and then nothing. I have to mention that the Bela have been plugged inverted (i.e P2 swapped with P1), but according to Pocketbeagle's pinout, there should not have been any "5v on 3.3v" connection, since the Headers are symmetrical as far as the Vout and 3.3V pins are concerned, and the board is powered through USB so Vin is 0V.
When I plug the board after the Pocketbeagle is started, the codec is getting very hot, and the bela consumes 0.8A (1A vs 0.2A when Pocketbeagle is running alone)
Is anybody aware of anything that could have been fried when plugging the Bela inverted, and in such case, is there any trick for fixing (replacing the codec, the regulator...) ?
Thanks
Guillaume