Has anyone tried to use the two amplified output in mono-bridged mode?
Below there's a configuration that generally works on most audio amp (including inverting the phase of one of the two channels).
Mono Signal --> Dac~ 1
Mono Signal * (-1) --> Dac~ 2
Amp Out L (+) --> Speaker (+)
Amp Out L (-) --> Amp Out R (-) --> GND
Amp Out R (+) --> Speaker (-)
Before diving into the schematics of the board and datasheet of the components (or just trying risking to damage the board), I'm wondering if anyone has any insight on this.
Best
Stefano